Purchase a new one.
Toilet flange sits toilet off floor.
The part you ll need is an adapter called a super flange or spanner flange.
A toilet is a necessity in any home and proper installation is a must to ensure that it works well.
Leaky broken or misaligned toilets are a hassle for everyone involved.
The last option when your flange is too high is to replace it.
If your flange sits even or below the floor then it s wrong.
Make sure you don t crack the pipe or you may be in trouble.
It has to sit evenly on top of the finished floor.
When a flange is installed improperly and there is a gap below the flange.
Lift off the toilet and set it aside.
This is usually the more popular choice mainly because it is easier and can really do the trick if your broken toilet flange is iron or metal.
Fix broken toilet flange.
This is very important.
If the previous flange is too low purchase one that is designed to sit on the finished floor and provide the optimum toilet flange height.
The higher a flange sits above the floor the greater the likelihood of poor fitting and problems with the toilet leaking.
If the flange is sitting only about inch of the floor it is possible to use a wax ring sealed in place to fix this small gap.
The plumbers left the flange up 3 8 or 1 2 in anticipation of a floor covering.
A key component to toilet installation is the closet flange.
Shut off the water to the toilet disconnect the supply hose from the toilet tanks and unbolt the toilet from the floor with a wrench.
The reason being is because the toilet recesses into the flange when fully installed but when the flange sits even or below the floor the toilet can t properly recess into the flange.
You ll need to remove your old flange and the fitting from the pipe coming up from your bathroom floor to do this.
Start by removing your toilet and breaking the outer flange portion off.
The fitting that connects the toilet to the drain pipe underneath.
The optimum toilet flange height is approximately inch above the floor to achieve the best seal and overall fit.
You can use a hammer and a chisel.
When a toilet is set the wax is pushed through the bolt slots.
