I replace an old valve that was leaking.
Toilet water shut off valve leaking australia.
Next remove the handle from the stem and then loosen and remove the packing nut.
Remove the old washer and slide on the new one.
Place the small container underneath the valve in case some water leaks into it while you do the repairs.
As the water begins filling the toilet s tank check for leaks around the new valve.
Hopefully this is enough to compress the rubber gasket so that it is sealed on the valve stem to prevent water leaks.
Use light steady pressure so you don t damage the water lines.
If there is a leak shut off the water empty the lines and unscrew the valve s compression nut.
When you re ready to get started shut off the water.
Water leak shut off valve fixing for a leaky toilet water shut off valve the easiest solution is to tighten the package nut 1 4 turn with a wrench.
Wrap the slip joint pliers jaws in masking tape to protect your shut off valve from any scratches caused by the sharp edges.
Tighten the packing nut on the toilet shutoff valve one eighth turn clockwise to try to seal a leak around the nut.
You can do this by turning the valve by the toilet base clockwise.
Water will stop flowing into the tank.
Tighten the packing nut.
Step 3 remove the nut.
Wrap cloth or masking tape on the plier s jaws to protect the nut s finish.
It is located inside the toilet tank at the bottom.
The chain hook must be removed and a new flapper set into its place.
To fix a leaking flapper valve turn the water shut off valve on the intake pipe just below the toilet tank to the closed position.
Flush the toilet and then remove the flapper valve.
Next shut off the main water supply to the toilet and detach and drain the pipes using a wrench or pliers.
Then follow our step by step instructions on our article.
I can see after watching this video that i need to get back there clean everything up possibly pull off the trim.
Then flush the toilet to empty the tank.
First shut off the water to the leaking water valve.
Reinstall the packing nut tighten lightly with a wrench don t over tighten at this or any other point and reattach the handle.
Step 3 remove the screw in the center of the shutoff valve handle using a screwdriver.
Do not remove the valve just tighten the packing nut.
Turn on all the faucets and flush all the toilets associated with the main shutoff valve to empty the pipes of water.
