Tongue And Groove Flooring Installation Tools

Begin the first row of flooring by placing the planks with the tongue side facing the wall.

Tongue and groove flooring installation tools.

The ends and edges of all laminate flooring have interlocking tongue and groove profiles that would get crushed and ruined if you hit them directly with a mallet or hammer. Manual flooring nailers will work but are tougher and slower to use. For instance solid hardwood flooring is typically nailed down during installation while tongue and groove engineered flooring is usually clicked together or completely glued down. For tongue and groove flooring drive a nail at a 45 degree angle through the tongue then conceal it by engaging the groove of the next board.

Install the second plank next to the first by aligning the tongue into the groove and press the plank down to snap it in place. Install tongue and groove wood floors on a ceiling. The pneumatic tool provides consistent power to countersink fasteners enough momentum to draw boards together and the speed to get the job done quicker than with manual flooring nailers. They re also handy for repair work especially floating floors that have been glued by tongue and groove.

When you come to the end of the first row cut the length of plank needed to complete the row. Be sure to countersink the nail drive it slightly below the surface of the wood to prevent interference in the joint. Special bits also allow them to cut grooves on end joints for tongue and groove strip fits and molding. Problem boards can then be nailed into place.

Shaped to conform to the tongue and groove profile on the ends of laminate flooring the block sits tight against the laminate. Pre finished wood veneer tongue and groove flooring underlayment rubber mallet tap block. Flooring installers can use a router for removing wood for decorative inlay and borders. This is where a tapping block comes in.

The solid pull bar slips between the wall and board allowing you to tap the board tongue into groove. The traditional method of nailing hardwood tongue and groove flooring is to drive nails at an angle through the tongue of a plank and into the subfloor below but this is time consuming and can. Diaz recommends using a pneumatic flooring nailer for installation. The type of installation you choose will depend on your subfloor budget lifestyle and the type of wood flooring you select.

This floor installation kit contains the essential tools for installing wood and laminate flooring.